The Van's RV-3 is a single-seat, single-engine, low-wing kit aircraft sold by Van's Aircraft.Vandermeullen, Richard: 2012 Kit Aircraft Buyer's Guide, Kitplanes, Volume 28, Number 12, December 2011, page 74. Belvoir Publications. Unlike many other aircraft in the RV line, the RV-3 is only available as a tail-wheel equipped aircraft, although it is possible that some may have been completed by builders as nose-wheel versions. The RV-3 is the genesis design for the rest of the RV series, all which strongly resemble the RV-3. The RV-4 was originally developed as a two-seat RV-3.
Development
The architect of the line of Van's aircraft, Richard VanGrunsven, designed the RV-3 in the late 1960s after experience flying the Stits Playboy amateur-built aircraft. The RV-3 started out as an attempt to maintain the Playboy's layout and concept but to improve it in every regard. The RV-3 was designed to have light handling, aerobatic capabilities, fast cruise speeds, and short field STOL capabilities. The RV-3 was also designed from the start for serious travel and as such carries 30 US gallons of fuel, giving it a range of about 600 statute miles. The design horsepower is 100–150, typically using a Lycoming O-235 or Lycoming O-320 powerplant. Some builders have fitted RV-3s with more powerful engines, however.Plane and Pilot, 1978 Aircraft Directory, page 159, Werner and Werner, Santa Monica CA 1978Armstrong, Kenneth, Choosing Your Homebuilt – The One You'll Finish And Fly, pages 363, Butterfield Press, Templeton CA 1993.Bowers, Peter M, Guide to Homebuilts, page 234, 9th Edition, TAB Books Blue Ridge Summit PA, 1984.
The RV-3 uses a NACA 23012 airfoil on a constant chord wing. Construction is semi-monocoque of predominantly 2024-T3 aluminum sheet. The wings are built around an aluminum I-beam spar with a lighter rear spar. The aircraft has plain flaps operated by a handle. The main landing gear is attached directly to the welded steel engine mount and consists of tapered, sprung steel rods. Construction time for the RV-3 is reported to be 1300 hours for a first time builder.
The very first RV-3 built by VanGrunsven won "Best Aerodynamic Detailing" at the 1972 EAA Oshkosh Convention. It also won the 1973 AC/EAA Efficiency Contest.
There is an RV-3A model, but its designation does not follow VanGrunsven's normal system, where "A" models are nosewheel equipped versions. An RV-3A is an early RV-3 that has undergone rear spar and wing root upgrades as described in Van's publication CN-1. Due to ongoing structural concerns, the production of RV-3 kits was suspended in 1996. Continued customer demand for the single seat design resulted in VanGrunsven engineering a new wing for the RV-3. Production of kits was restarted a few years later. New aircraft completed since the wing redesign and aircraft that have been retrofitted with the new wing are referred to as an RV-3B.
By February 2023, 305 RV-3s had been completed and flown.
Aircraft on display EAA AirVenture Museum – RV-3 Prototype N17RV
Specifications (RV-3B)
See also
References
External links
Van's Aircraft RV-3