The "Plan for Establishing Uniformity in the Coinage, Weights, and Measures of the United States" was a report submitted to the U.S. House of Representatives on July 13, 1790, by Secretary of State Thomas Jefferson.
At the First United States Congress, which met in 1789 when the decimal metric system had not yet been developed in France, the system of units to be used in the U.S. was one point of discussion. Under the Constitution (article I, section 8), the Congress has the constitutional right to decide on a standard of weights and measures. On January 8, 1790, George Washington urged Congress to address the need for the uniform system of weights and measures, and on January 15, 1790, the House of Representatives requested Thomas Jefferson to draw up a plan.
The decimal dollar had already been agreed upon in principle in 1785,Journals of the Continental Congress, Wednesday, July 6, 1785 but would not be implemented until after the enactment of the Coinage Act of 1792. After correspondence with William WaringWilliam Waring (1790-01-30): A Plan for Weights and Measures archived at Library of Congress and others, Jefferson proposed two systems of units in mid-1790. The first was evolutionary, and was based on refinement of the definitions of the units of the existing English system, as well as simplification of their relationship to each other. The second system was revolutionary, and was based on units linked by powers of ten, very similar to the decimal metric system which would be proposed in France. The base units for length, mass, and volume in Jefferson's revolutionary system (named the foot, the ounce, and the bushel, respectively) were relatively close in size to their pre-existing counterparts and bore identical names, although the manner in which they were defined was very different.
Jefferson's proposal was the world's first scientifically based, fully integrated, decimal system of weights and measures.
The seconds pendulum basis In coordination with scientists in France, Jefferson selected the seconds pendulum at 45° latitude as the basic reference. For technical reasons, he proposed using a uniform rod as the pendulum rather than a traditional pendulum. The pendulum was estimated to be 39.14912 English inches long (which at that time had not been defined to exactly 25.4 mm), or 1.5 times that for a vibrating rod (58.72368 inches).
+ Redefinition of the inch by the 45°N seconds pendulum or rod base pendulum vibrating rod foot original 39.14912 in 58.72368 in 304.801 mm ideal pendulum 36 in = 3 ft = 1 yd 54 in 331.463 mm ideal rod 40 in 60 in = 5 ft 298.317 mm practical rod 39.1 in 58.75 in 304.664 mm modern 39.13198 in 58.69796 in 304.8 mm
More traditional proposal In the evolutionary approach, the foot was to be derived from these lengths by a simple integer factor, which would be either three (pendulum) or five (rod), i.e. lengthening it from the traditional value of about 304 mm by slightly over 1 inch to ca. 331 mm or shortening it by about a quarter of an inch to ca. 298 mm. For practical purposes he wanted the rod to be (new) inches long, an increase of less than 0.045%.
For the mass units, the ounce as a base would equal the weight of one thousandth of a cubic foot of rain water at standard temperature.
+ Jeffersonian conservative proposal Length line in standard rod inch = 10 lines foot = 12 inches yard = 3 feet ell = feet fathom = 6 feet perch, pole = yards furlong = 40 poles mile = 8 furlongs league = 3 miles Area rood = 40 square poles acre = 4 roods Volume dry liquid gill = pint pint = quart quart = pottle pottle = gallon gallon = 270 cubic inches peck = 2 gallons bushel firkin = 4 pecks strike kilderkin = 2 bushels or firkins coomb barrel = 2 strikes or kilderkins quarter hogshead = 2 coombs or barrels tierce = 4/3 hogshead pipe, butt, puncheon = 2 hogshead ton = 2 pipes = 3 tierces = 4 quarters Mass grain = 1/24 pennyweight pennyweight = 1/18 ounce ounce = 1/1000 mH2O(1 cubic foot) pound = 16 ounces
Although the rundlet is mentioned as an existing measure for liquids equivalent to a kilderkin, it was omitted from the list of redefinitions.
Decimal system based on the foot Jefferson's proposed decimal system preceded the adoption in France of the decimal metric system, although both developed simultaneously. In France, the metre was to be defined as the ten-millionth part of an arc between the North Pole and the equator. Jefferson's system was based on the length of a rod oscillating seconds at 45 degrees latitude, with the foot defined as one fifth of the length of such a rod. Similar to the French system, Jefferson proposed a system of units linked directly by powers of ten. However, Jefferson's system did not make use of the concept of prefixes, which were of great importance in the French system. Instead, the names of old units were carried over into the new system for decimal multiples of the base units, giving them new values.
Asserting the value of such thorough reform to the existing system of weights and measures, the report stated:
The following table lists the units of the Jeffersonian decimal system, and their relationship with one another. The values of these units are based on Jefferson's proposal of a foot that was equal in length to one-fifth of a second rod, one fourth of an inch shorter than the foot in use at the time, and approximately equal to 0.298461684 m. For the mass units, the ounce as a base would equal the weight of a cubic inch of pure water at standard temperature.
+Jeffersonian decimal proposal Value relative to base unit SI equivalent USCS equivalent Length Point 0.0010.29846 mm11.75 mil (0.846 p) Line 0.012.9846 mm0.1175 in (0.705 P) Inch 0.12.9846 cm1.175 in Foot 12.9846 dm11.75 in Decad 10 2.9846 m9.792 ft Rood 1002.9846 dam97.92 ft (32.64 yd) Furlong 10002.9846 hm979.2 ft (1.484 fur) Mile 100002.9846 km1.85 mi Area Rood 1 = 1 rood28.9078 a9588.424 ft2 Double Acre 100.89078 ha2.2 acre Volume Metre 0.001 = 1 in32.6587 cL1.798 Tbsp Demi-pint 0.012.6587 dL8.99 fl oz Pottle 0.12.6587 L2.809 qt Bushel 1 = 1 ft32.6587 daL7.023 gal Quarter 102.6587 hL70.23 gal (2.23 bbl) Last, Double Ton 1002.6587 m3702.3 gal (93.89 ft3) Mass Mite 0.00012.6587 mg0.041 gr Minim, Demi-Grain 0.0012.6587 cg0.41 gr Carat 0.012.6587 dg4.103 gr Double Scruple 0.12.6587 g41.03 gr Ounce 1 mH2O(1 in3)2.6587 dag0.938 oz Pound 102.6587 hg9.38 oz Stone 1002.6587 kg5.86 lbKental 100026.587 kg58.6 lb Hogshead 10000265.87 kg586.14 lb
The transcript of the original document gives the value of a kental as 16 stones at one point and 10 stones in another point. 10 was presumably the intended value, given the otherwise consistent decimalization.
Subsequent developments Under the United States Constitution, Article 1 Section 8, Congress shall have power "To coin Money, regulate the Value thereof, and of foreign Coin, and fix the Standard of Weights and Measures". In his first annual message to Congress (what later came to be called "State of the Union Addresses") on January 8, 1790 (a few months before Jefferson's report to the House of Representatives), George Washington stated, "Uniformity in the currency, weights, and measures of the United States is an object of great importance, and will, I am persuaded, be duly attended to."The American Presidency Project, George Washington: First Annual Message, accessed October 13, 2006
Washington repeated similar calls for action in his secondThe American Presidency Project, George Washington: Second Annual Message, accessed October 13, 2006 and thirdThe American Presidency Project, George Washington: Third Annual Message, accessed October 13, 2006 annual messages (after Jefferson's report). Jefferson's decimal proposal had the support of Alexander Hamilton, James Madison, James Monroe, and George Washington. Robert Morris was a powerful opponent of the proposal. In late 1791 the Senate appointed a committee to report on the subject and make recommendations. The committee reported in April 1792, unanimously endorsing Jefferson's decimal system. The Senate was slow to act on the matter and while they delayed, events in France complicated the issue. Although French scientists working on a decimal system had originally supported using the seconds pendulum as a scientific basis, and Jefferson had deliberately matched his seconds pendulum proposal to the French one, based on a measurement at the latitude of Paris, the French decided to use the length of a meridian of the Earth instead of a seconds pendulum. This and other developments changed what had promised to be an internationally developed system into a strictly French project. Jefferson wrote, "The element of measure adopted by the National Assembly excludes, ipso facto, every nation on earth from a communion of measurement with them."
The Senate continued to consider Jefferson's two proposals, along with a number of new proposals, for several years. In 1795, a bill titled "An Act directing certain experiments to be made to ascertain uniform standards of weights and measures for the United States" was passed by the House and was approved by committee in the Senate, but on the last day of the session the Senate said it would consider the bill during the next session. The bill was never taken up again. In 1795, the Northwest Indian War, which for years had prevented the surveying and sale of land in the Northwest Territory came to an end. A land rush of settlers, surveyors, squatters, and others rapidly pushed into the region and the federal government had a sudden and intense need to establish a method for surveying and selling land. On May 18, 1796, Congress passed "an Act for the sale of land of the United States in the territory northwest of the River Ohio, and above the mouth of the Kentucky River". This law defined a survey grid system of 6–mile–square townships divided into 1–mile–square sections, with the defining unit being the chain, specifically Gunter's chain. This was the first unit of measurement designated into law by Congress. This law and the way it defined the survey grid ended debate over Jefferson's decimal system.
Origins
The proposal by William Waring from 30 January 1790A Plan for the Regulation of Weights & Measures, respectfully proposed to the Legislature of the United States was similarly decimalized as Jefferson's more radical proposal, but introduces many new names for units and its base is the equatorial seconds pendulum, i.e. determined at 0° not 45°, called pend or federal ell. A federal gallon of 0.004 cubic pends, i.e. slightly less than 4 liters and thus similar in size to the English wine gallon, is suggested as a more traditional base for liquid measures; and 9 such gallons, since almost equal to a Winchester bushel, or, more systematically, 10 gallons would form the base for dry measures. Inspired by the Avoirdupois system defining 1 cubic foot of water to weigh 1000 ounces of which there are 16 to the pound, Waring suggests a federal pound of half a cubic hand of water, which would be just short of 500 g.