In astronomy, weak gravitational lensing is a technique to map the mass distribution of astronomical objects. As predicted by general relativity, the presence of any mass bends the path of light passing near it, producing gravitational lensing. This effect rarely produces the giant arcs and multiple images associated with strong gravitational lensing. Most lines of sight in the universe are thoroughly in the weak lensing regime, in which the deflection is impossible to detect in a single background source. However, even in these cases, the presence of the foreground mass can be detected, by way of a systematic alignment of background sources around the lensing mass. Weak gravitational lensing is thus an intrinsically statistical measurement, but it provides a way to measure the masses of astronomical objects without requiring assumptions about their composition or dynamical state.
The field was pioneered by J. Anthony Tyson in the 1990s.
Methodology
Gravitational lensing acts as a coordinate transformation that distorts the images of background objects (usually galaxies) near a foreground mass. The transformation can be split into two terms, the convergence and shear. The convergence term magnifies the background objects by increasing their size, and the shear term stretches them tangentially around the foreground mass. Moreover, the higher order image distortion, which is called flexion can bend the galaxy images into arclets.
To measure this tangential alignment, it is necessary to measure the ellipticities of the background galaxies and construct a statistical estimate of their systematic alignment. The fundamental problem is that galaxies are not intrinsically circular, so their measured ellipticity is a combination of their intrinsic ellipticity and the gravitational lensing shear. Typically, the intrinsic ellipticity is much greater than the shear (by a factor of 3-300, depending on the foreground mass). The measurements of many background galaxies must be combined to average down this "shape noise". The orientation of intrinsic ellipticities of galaxies should be almost entirely random, so any systematic alignment between multiple galaxies can generally be assumed to be caused by lensing.
Another major challenge for weak lensing is correction for the point spread function (PSF) due to instrumental and atmospheric effects, which causes the observed images to be smeared relative to the "true sky". This smearing tends to make small objects more round, destroying some of the information about their true ellipticity. As a further complication, the PSF typically adds a small level of ellipticity to objects in the image, which is not at all random, and can in fact mimic a true lensing signal. Even for the most modern telescopes, this effect is usually at least the same order of magnitude as the gravitational lensing shear, and is often much larger. Correcting for the PSF requires building a model for the telescope for how it varies across the field. Stars in our own galaxy provide a direct measurement of the PSF, and these can be used to construct such a model, usually by interpolating between the points where stars appear on the image. This model can then be used to reconstruct the "true" ellipticities from the smeared ones. Ground-based and space-based data typically undergo distinct reduction procedures due to the differences in instruments and observing conditions.
Angular diameter distances to the lenses and background sources are important for converting the lensing observables to physically meaningful quantities. These distances are often estimated using photometric redshifts when spectroscopic redshifts are unavailable. Redshift information is also important in separating the background source population from other galaxies in the foreground, or those associated with the mass responsible for the lensing. With no redshift information, the foreground and background populations can be split by an apparent magnitude or a color cut, but this is much less accurate.
Weak lensing by clusters of galaxies
Galaxy clusters are the largest gravitationally bound structures in the Universe with approximately 80% of cluster content in the form of dark matter. The gravitational fields of these clusters deflect light-rays traveling near them. As seen from Earth, this effect can cause dramatic distortions of a background source object detectable by eye such as multiple images, arcs, and rings (cluster strong lensing). More generally, the effect causes small, but statistically coherent, distortions of background sources on the order of 10% (cluster weak lensing). Abell 1689, CL0024+17, and the Bullet Cluster are among the most prominent examples of lensing clusters.
History The effects of cluster strong lensing were first detected by Roger Lynds of the National Optical Astronomy Observatories and Vahe Petrosian of Stanford University who discovered giant luminous arcs in a survey of galaxy clusters in the late 1970s. Lynds and Petrosian published their findings in 1986 without knowing the origin of the arcs. In 1987, Genevieve Soucail of the Toulouse Observatory and her collaborators presented data of a blue ring-like structure in Abell 370 and proposed a gravitational lensing interpretation. The first cluster weak lensing analysis was conducted in 1990 by J. Anthony Tyson of Bell Laboratories and collaborators. Tyson et al. detected a coherent alignment of the ellipticities of the faint blue galaxies behind both Abell 1689 and CL 1409+524. Lensing has been used as a tool to investigate a tiny fraction of the thousands of known galaxy clusters.
Historically, lensing analyses were conducted on galaxy clusters detected via their baryon content (e.g. from optical or X-ray surveys). The sample of galaxy clusters studied with lensing was thus subject to various selection effects; for example, only the most luminous clusters were investigated. In 2006, David Wittman of the University of California at Davis and collaborators published the first sample of galaxy clusters detected via their lensing signals, completely independent of their baryon content. Clusters discovered through lensing are subject to mass selection effects because the more massive clusters produce lensing signals with higher signal-to-noise ratio.
Observational products The projected mass density can be recovered from the measurement of the ellipticities of the lensed background galaxies through techniques that can be classified into two types: direct reconstruction and inversion. However, a mass distribution reconstructed without knowledge of the magnification suffers from a limitation known as the mass sheet degeneracy, where the cluster surface mass density κ can be determined only up to a transformation where λ is an arbitrary constant. This degeneracy can be broken if an independent measurement of the magnification is available because the magnification is not invariant under the aforementioned degeneracy transformation.
Given a centroid for the cluster, which can be determined by using a reconstructed mass distribution or optical or X-ray data, a model can be fit to the shear profile as a function of clustrocentric radius. For example, the singular isothermal sphere (SIS) profile and the Navarro-Frenk-White (NFW) profile are two commonly used parametric models. Knowledge of the lensing cluster redshift and the redshift distribution of the background galaxies is also necessary for estimation of the mass and size from a model fit; these redshifts can be measured precisely using spectroscopy or estimated using photometry. Individual mass estimates from weak lensing can only be derived for the most massive clusters, and the accuracy of these mass estimates are limited by projections along the line of sight.
Scientific implications
Cluster mass estimates determined by lensing are valuable because the method requires no assumption about the dynamical state or star formation history of the cluster in question. Lensing mass maps can also potentially reveal "dark clusters," clusters containing overdense concentrations of dark matter but relatively insignificant amounts of baryonic matter. Comparison of the dark matter distribution mapped using lensing with the distribution of the baryons using optical and X-ray data reveals the interplay of the dark matter with the stellar and gas components. A notable example of such a joint analysis is the so-called Bullet Cluster. The Bullet Cluster data provide constraints on models relating light, gas, and dark matter distributions such as Modified Newtonian dynamics (MOND) and Λ-Cold Dark Matter (Λ-CDM).
In principle, since the number density of clusters as a function of mass and redshift is sensitive to the underlying cosmology, cluster counts derived from large weak lensing surveys should be able to constrain cosmological parameters. In practice, however, projections along the line of sight cause many false positives. Weak lensing can also be used to calibrate the mass-observable relation via a stacked weak lensing signal around an ensemble of clusters, although this relation is expected to have an intrinsic scatter. In order for lensing clusters to be a precision probe of cosmology in the future, the projection effects and the scatter in the lensing mass-observable relation need to be thoroughly characterized and modeled.
Galaxy-galaxy lensing Galaxy-galaxy lensing is a specific type of weak (and occasionally strong) gravitational lensing, in which the foreground object responsible for distorting the shapes of background galaxies is itself an individual field galaxy (as opposed to a galaxy cluster or the large-scale structure of the cosmos). Of the three typical mass regimes in weak lensing, galaxy-galaxy lensing produces a "mid-range" signal (shear correlations of ~1%) that is weaker than the signal due to cluster lensing, but stronger than the signal due to cosmic shear.
History J. Anthony Tyson and collaborators first postulated the concept of galaxy-galaxy lensing in 1984, though the observational results of their study were inconclusive. It was not until 1996 that evidence of such distortion was tentatively discovered, with the first statistically significant results not published until the year 2000. Since those initial discoveries, the construction of larger, high resolution telescopes and the advent of dedicated wide field galaxy surveys have greatly increased the observed number density of both background source and foreground lens galaxies, allowing for a much more robust statistical sample of galaxies, making the lensing signal much easier to detect. Today, measuring the shear signal due to galaxy-galaxy lensing is a widely used technique in observational astronomy and cosmology, often used in parallel with other measurements in determining physical characteristics of foreground galaxies.
Stacking Much like in cluster-scale weak lensing, detection of a galaxy-galaxy shear signal requires one to measure the shapes of background source galaxies, and then look for statistical shape correlations (specifically, source galaxy shapes should be aligned tangentially, relative to the lens center.) In principle, this signal could be measured around any individual foreground lens. In practice, however, due to the relatively low mass of field lenses and the inherent randomness in intrinsic shape of background sources (the "shape noise"), the signal is impossible to measure on a galaxy-by-galaxy basis. However, by combining the signals of many individual lens measurements together (a technique known as "stacking"), the signal-to-noise ratio will improve, allowing one to determine a statistically significant signal, averaged over the entire lens set.
Scientific applications Galaxy-galaxy lensing (like all other types of gravitational lensing) is used to measure several quantities pertaining to mass: